Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED
Unpacking your ice maker
1.
Remove the exterior and interior packaging. Check if ice basket and ice scoop
inside. If any parts are missing, please contact our customer service.
2.
Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank
& ice basket.
3.
Put the ice maker on a level & flat counter top without direct sunlight and
other sources of heat (i.e.: stove, furnace, radiator). Maker sure that there is at
least 4 inches gap between the back & LH/RH sides with the wall.
4.
Allow one hour for the refrigerant fluid to settle before plugging the ice maker
in.
5.
The appliance must be positioned so that the plug is accessible.
CAUTION: HEALTH RISK
Fill with potable water only. Only use drinking water.
Assemble handle
Rotate the handle to the same angle as the mounting hole on the machine. Put it
on the machine.
Connecting to electrical power
This appliance requires a standard 220-240 Volt, 50 Hz electrical outlet with good
grounding means.
EN
21
Publicidad
