Publicidad
Idiomas disponibles
Idiomas disponibles
1. GENERAL WARNINGS FOR THE INSTALLER
RISK OF ELECTRIC SHOCK, EXPLOSION OR ELECTRIC ARC
• Shut down all equipment, including connected devices, before removing any lid or door, or before
installing/uninstalling accessories, hardware, cables or wires, except for the conditions specified in the user
manual for this equipment.
• To verify that the system is out of voltage, always use a correctly calibrated voltmeter at the rated value
of the voltage.
• Before returning the live unit, reassemble and secure all covers, hardware and cables. Make sure that the
cable inlet is sealed to prevent insect entry and moisture formation.
• Use this equipment and all products connected only to the specified voltage.
• If there is a risk of damage to personnel and/or equipment, use the necessary safety interlocks.
• Do not disassemble, repair or modify the equipment.
• This product is not suitable for installation in applications where it may come into contact with explosive
or flammable atmosphere.
Failure to comply with these instructions will result in death or serious injury.
• Do not expose the equipment to liquid substances.
• Do not exceed the temperature and humidity ranges specified in the technical data and leave the slit area
ventilated.
• Only connect compatible accessories in the user manual.
• Use only cables of appropriate cross-section as indicated in the section "GUIDELINES FOR ELECTRICAL
CONNECTIONS". Tighten the connections in accordance with the technical specifications for the tightening
torques and verify the correct wiring.
• Electrical cables must not come into contact with parts that can heat and parts of the automation in
motion.
Failure to comply with these instructions will result in death or serious injury.
• If the battery is intact, store and handle carefully, there is no danger (it is recommended to handle the
batteries in a ventilated place, do not smoke, eat or drink during assembly).
• Do not expose to temperatures above 100 ºC (temperature <85 ºC recommended).
• Avoid short circuit, crushing and exposure to heat sources.
• Do not disassemble, drill, heat or wet batteries or battery packs, do not throw batteries into the fire.
• Substances to avoid: water, oxidizing agents, alkalis.
• Keep new and used batteries out of the reach of children.
• If the battery compartment does not close tightly, suspend the use of the product and keep it out of reach
of children.
• If you suspect that the batteries have been swallowed or inserted into other body orifices, seek medical
attention immediately.
• Only use batteries of the specified type. Risk of explosion if battery is replaced with wrong type.
Failure to comply with these instructions will result in death or serious injury.
6-1620173M - rev. 0 - 30/10/2023
RISK OF ELECTRIC SHOCK AND/OR FIRE
DANGER - BATTERIES
RISK OF OVERHEATING, EXPLOSION, FIRE OR BURN
DANGER
DANGER
Translated from the original language - English - 3
Publicidad
