Publicidad
Idiomas disponibles
Idiomas disponibles
5.3 - CONNECT THE SENSITIVE SAFETY EDGE TO THE TRANSMITTER
• Insert the battery into the dedicated housing and connect the connector to the board.
6. PROGRAMMING
6.1 - ASSOCIATION BETWEEN TCOO AND RCOO (LEARNING)
• The learning procedure is automatically abandoned for TIME OUT after 30 seconds from the last key
pressed on the RCOO.
• During the learning procedure both outputs remain alert.
• You can map the association between TCOO input and RCOO outputs again by repeating the learning
procedure and setting the desired configuration.
• Make sure the devices are turned on properly.
• Press and hold the PROG/RESET button for at least 3 seconds, when the PROG/RESET LED lights up fixed release the button.
• At this stage you can select in which output (OUT1 and/or OUT2) you want to learn an input of a TCOO. Use the PROG/RESET
button to select the desired option.
LED L1
LED L2
FLASHING
OFF
FLASHING
FLASHING
FLASHING
• Press the TCOO button you want to associate (TEST1 or TEST2).
• In the RCOO the L1 and L2 LEDs both light up and the buzzer makes two beeps to confirm the programming.
• After the procedure the LED PROG/RESET turns off.
6-1620173M - rev. 0 - 30/10/2023
• Connect the safety sensitive edge to the desired input (EDGE1 or EDGE2).
• Depending on the type of edge used, select the corresponding type in the DIP-
SWITCH selector.
Configuration example for EDGE1 input:
EDGE1 8K2
OFF
The input will be learned on the OUT1 output.
The input will be learned on the OUT2 output.
The input will be learned on the OUT1 and OUT2 outputs.
RESISTIVE EDGE 8K2
ON
MECHANICAL EDGE
OFF
WARNING
DESCRIPTION
8K2
Translated from the original language - English - 13
Publicidad
