Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
OF CARTON
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1-
Handle
1 - Handle Grip
2 - Cap Screws
2 - 1/4-20 Hex Nuts
2 - Retainer Clips
2 - Flat Washers
2 - Rubber Bumpers
2 - Screws, 1/4-20 x 3/4" (19 ram)
TOOLS
REQUIRED
FOR
ASSEMBLY
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
UNPACKING
Remove unit from carton and discard
all packaging. NOTE: Save all parts
bags.
TO iNSTALL
HANDLE
The wheels and
handle do not
provide adequate clearance, stability,
or support for pulling the unit up and
down stairs or steps. The unit must be
lifted or pushed up a ramp. Do not lift
the unit by the manifold assembly, the
unit could be damaged.
1.
2.
To make installation easier,
submerge handle grip into warm
soapy water. Remove handle grip
from soapy water and slide onto
handle.
Insert the open end of the
handle under the saddle. Before
attaching handle, you may have
to pull the open ends of the
handle apart so they fit tightly
against the side of the saddle.
Looking in from the open end of
the saddle, position the handle
toward the two bent tabs, on the
inside walls of the saddle.
Open End
Of Handle
3.
Slowly push the open ends of the
handle onto both tabs at the same
time. Continue pushing the handle
into the saddle until the holes on
the side of the saddle and handle
are in line.
Saddle Hole
Bent Tabs
4.
Guide the straight end of each
retaining clip through the saddle
hole and both handle holes.
5.
Rotate each retaining clip and
press down until it snaps into
place over the handle.
Retaining
Clip
6.
If the handle has excessive move-
ment, it is improperly installed.
Check the following.
10- ENG
Publicidad
