Publicidad
Idiomas disponibles
Idiomas disponibles
User-maintenance instructions
After using the Pore Cleanser both the
main body and the cup can be washed
using water.
1. Put some water (warm if you like) in a
washbowl. Do not use hot water (over
70°C(150°F)).
2. Remove the cup, soak the suction point
in the water, and clean for approximately
15 seconds while keeping the suction
increase button pressed.
Note: The suction increase button must be
kept pressed while cleaning.
* Do not use detergent.
* Do not press the mist button while
cleaning.
3. Lift the main body out of the water and
release your finger from the suction in-
crease button. While the pore cleanser
is still on, shake the main body about
ten times to remove the water from in-
side.
- | When shaking the
main body, make
sure the suction in-
crease
button is
facing down.
4. Drain the water from the water tank and
leave it to dry with the "water tank cap"
open.
5. Wipe the main body and the cup with
facial tissues or cotton swabs, taking par-
ticular care to clean carefully inside the
cup.
How to clean the Pore Cleanser
@ Suction point (filter)
Turn the switch off and remove any ac-
cumulated dirt using the cleaning brush
that is provided.
* Do not use the cleaning needle to clean
this.
EN
$
Cleaning brush
Cleaning needle cap
@ Water tank
Turn the switch off and clean the inside
of the water tank using the cleaning brush
that is provided.
Publicidad
