Correct Handling Of Machine; Points In Operation And How To Stop - Makita EE2650H Manual De Instrucciones

CORRECT HANDLING OF MACHINE

– Before edging, water the area to soften the ground and make edging easier.
– Before edging, check the area and remove all obstacles and objects that
could be thrown.
– Plan to edge regularly to make it easier to keep a neat edge and to avoid
having to make more than one pass.
Note:
Blade depth may have to be adjusted due to differences in height between the
hard surface and the top of the grass.
– Adjust the blades' depth of cut to produce a fine cut between sidewalk and
grass using a minimum blade depth, usually with about 13 mm (1/2") of the
blade into the ground.
Adjusting the blade depth
– Loosen the nut on the wheel.
– Move the wheel and adjust the height according to the operation, then tighten
the nut.

POINTS IN OPERATION AND HOW TO STOP

CAUTION:
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the petrol edger on a clean piece of ground taking care that the cutting tool does not
come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION.
3) Primer pump
Continue to push the primer pump (2) until fuel enters into the primer pump.
(In general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
OPERATION
(2)
12
STOP
(1)