Publicidad
Idiomas disponibles
Idiomas disponibles
To charge the battery
Charge the battery before the first use.
Note:
The battery does not charge if the battery
temperature is more than +35 °C.
1. Connect the power cord for the battery charger in a
grounded mains.
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 38)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Battery status LED on the battery
charger
The red LED (A) and the green LED (B) on battery
charger show the battery status. Refer to
LED on the product on page 16 .
(Fig. 39)
LED
The green LED flashes
quickly.
The green LED flashes
slowly.
The green LED is on.
The red LED is on.
The red LED flashes
quickly.
Battery status LED on the product
When the battery is installed in the product, the LEDs on
the product show the battery status.
(Fig. 40)
16
Make sure that the
Do not pull the power
Battery status
Battery status
The battery is charging.
The battery is 80% charg-
ed.
The battery is fully charg-
ed.
Battery status
Refer to
LED on the product on
page 16 .
Battery status
Refer to
LED on the product on
page 16 .
LED
Battery status
LED 1, 2 and 3 are
Fully charged.
lit.
LED 1 and 2 are lit.
Sufficiently charged
LED 1 is lit.
The battery power is low.
LED 1 flashes.
The battery is empty. The bat-
tery status indicator flashes.
Charge the battery. Refer to
charge the battery on page 16 .
To connect the battery to the product
WARNING:
products of the POWER FOR ALL system
18V.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide into the holder easily,
if not, it is not installed correctly.
(Fig. 41)
3. The battery locks into position when you hear a click.
To start the product
1. Push and hold the on/off button until the green LED
comes on. (Fig. 42)
2. Push the power trigger lockout and the power
trigger. The cutting equipment starts to rotate.
To adjust the loop handle and
telescopic shaft
1. Press the loop handle adjustment button.
(Fig. 43)
2. Adjust the loop handle to a suitable angle.
3. Release the loop handle adjustment button.
4. Loosen the lever on the shaft. (Fig. 44)
5. Set the necessary length on the shaft.
6. Close the lever and tighten the screw.
Note:
The two loop handle positions in the
following illustration are only for transportation and/or
storage.
(Fig. 45)
To
Only use the battery with
1885 - 005 - 18.12.2023
Publicidad
