Husqvarna Aspire T28-P4A Manual De Usuario página 17

Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The product shuts
down after 3 minutes.
To operate the product
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line
into the grass. (Fig. 46)
2. Decrease the length of the trimmer line by 8–10 cm/
3.15–4 in.
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION:
that are hit by the trimmer line, increases
the wear on the trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass. (Fig. 47)
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
WARNING:
you do maintenance.
Maintenance
Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
1885 - 005 - 18.12.2023
Cut grass. Other objects
Maintenance
Read and understand the
Remove the battery before
3. Move the product from side to side when you cut
grass. (Fig. 48)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
To stop the product
1. Release the power trigger and the power trigger
lockout.
2. Push the on/off button until the green LED goes off.
3. Push the release button on the battery and remove
the battery from the product. (Fig. 49)
To replace trimmer line
Refer to the last page of this operator's manual.
The following is a list of the maintenance steps that you
Maintenance on page 17
must do on the product. See
for more information.
Daily
X
X
X
X
X
Clean the trimmer head
Weekly Monthly
17