Orbegozo TRM 16 Manual De Instrucciones página 20

TRM 16 TRM 33 TRM 53 TRM 83 TRM 103
BRIEF INTRODUCTION OF PRODUCT STRUCTURE
Model Volume (L)
TRM 16 15
TRM 33 30
TRM 53 50
TRM 83 80
TRM 103 100
METHODS OF INSTALLATION
Note: Please be sure to use the accessories provided by our company to install this electric water
heater. This electric water heater cannot be hung on the support until it has been confirmed to be
firm and reliable. Otherwise, the electric water heater may drop off from the wall, resulting in
damage of the heater, even serious accidents of injury. When determining the locations of the bolt
holes, it shall be ensured that there is a clearance not less than 0.2mm on the right side of the
electric heater, to convenient the maintenance of the heater if necessary.
1. Installation of the main machine:
a. This electric water heater shall be installed in the solid wall. If the strength of the wall
cannot bear the load equal to two times of the total weight of the heater fully with water,
it is necessary to install a special support.
b. After selecting a proper location, determine the positions of the two install holes used for
expansion bolts with hook (determined according to the specification of the product you
select). Make two holes in the wall with the corresponding depth by using a chopping bit
with the size matching the expansion bolts attached with the machine, insert the screws,
make the hook upwards, tighten the nuts to fix firmly, and then hang the electric water
heater on it.
Rated
Rated
Pressure
Power (W)
(Mpa)
1500 0,75
1500 0,75
1500 0,75
1500 0,75
1500 0,75
Max Temp. Waterproof
Water (ºC) grade
75 IPX4
75 IPX4
75 IPX4
75 IPX4
75 IPX4
20