Orbegozo TRM 16 Manual De Instrucciones página 23

TRM 16 TRM 33 TRM 53 TRM 83 TRM 103
5. For the use of the first time (or the first time use after maintenance or clean), the heater
cannot be switched on until it has been filled fully with water. When filling the water,
at least one of the outlet valves at the outlet of the heater must be opened to exhaust
the air. This valve can be closed after the heater has been filled fully with water.
6. During heating, there may be drops
of water dripping from the pressure
release hole of the one-way safety
valve. This
phenomenon. If there is a large
amount of water leaked, please
contact
maintenance personnel for repair.
This pressure release hole shall,
under no circumstances, be locked;
otherwise,
damaged, even resulting in safety
accidents.
7. The drainage pipe connected to the pressure release hole must be kept sloping
downwards.
8. Since the water temperature inside the heater can reach up to 75ºC, the hot water must
not be exposed to human bodies when it is initially used. Adjust the water temperature
to a proper point to avoid scald.
9. In order to drain away the water inside the inner container, it can be drained away from
the exit port (twist the thread screw of the exit port off), and it also can be drained
away from the one-way safety valve (twist the thread screw off the one-way safety
valve, and lift the drain handle upwards).
10. If the flexible power supply cord is damaged, the special supply cord provided by the
manufacturer must be selected, and replaced by the professional maintenance
personnel.
11. If any parts and components of this electric water heater are damaged, please, contact
with the professional maintenance personnel for repair, and use the special spare parts
and components provided by our company.
is a normal
with professional
the heater maybe
23