Publicidad
Rev.1 16/03/2018
ENG
Pag.56
Connections
! IMPORTANT
Electrical connection
The insert is equipped with a three-pole cable (Fig.2), for a correct installation it is necessary to provide the dedicated electrical
connection under magneto-thermic (Fig.1) of adequate size according to the absorption of the generator in order to guarantee the
maximum safety of the installation.
Testing and commissioning
Stove start-up must be preceded by testing, which includes an operational check of the following elements:
•
connection to the smoke evacuation system;
•
checking that all materials used to build the smoke duct, chimney and chimney pot are regulation and suitable for use.
The testing is positive only when all operational phases have been completed without any anomaly being detected.
A1 Fume extraction fan
A2 Auger's mortor
A5 Auger's motor additional
tank*
A6 Igniter
A7 Heating pump A9
A8 Heating pump coupled to
second pump A10
A9 Three ways motor valve*
A10 Sanitary pump coupled
to heating pump A8*
A12 Boiler consent AUX*
B1 Water probe safety boiler
(S1)
B2 Water probe heating (S2)
B3 Fume probe
B4 Room thermostat/Puffer
heating thermostat*
B5 Water pressure tranducer
B6 Level pellet 1
B7 Level pellet 2
B8 Water probe sanitary
boiler (S3)*
B9 Flowswhitch/ thermostat
sanitary boiler*
B12 Fume exttractor verifier
encoder
B13 Air flow meter
B14 Pressure switch
B15 Thermostat safety pellet
B16 Thermostat safety H2O
B17 Room probe
B18 Security Microswitch
firedoor-ash
*Opt.
use and maintenance manual
HR EVO 170 - 250
The connections must be set up by a technician that is qualified and/or authorised by the
Manufacturer.
Fig.1
Fig.2
SET
vista anteriore
PNO100503PX00
18.04.2014
V:2.0
MICRONOVA S.R.L.
Personalizzazione per: Micronova
File: stufa orizzontale Touch slim.cdr
Formato file: pdf vettoriale
coralDRAW X5
Dimensioni:99 x 55,5mm.
Disegnatore: Michele Rossetti
Grigio tortora
non conduttivo
Nero 10%
non conduttivo
Trasparente
Biadesivo 3M 9088
Ribassamento 1mm.
vista posteriore
Publicidad
