Dometic WAECO CoolMatic MR-07 Instrucciones De Uso página 26

_MR-07_MH-07.book Seite 26 Freitag, 16. September 2011 4:42 16
Installing and connecting the device
6.3 Removing the transport protection
The device has a locking mechanism to protect it during transport. The fol-
lowing settings are possible:
Position 1 (transport lock): (fig. 6 1, page 5). The door is locked and se-
cured. To open the door, turn the bolt to position 2.
Position 2: (fig. 6 2, page 5). The door can be opened.
Position 3 ("VENT" position): (fig. 6 3, page 5). The door is slightly open,
but fixed in position. Use this position, for example, if you are not going to
use the device for a long time.
6.4 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (fig. 7, page 5):
➤ Remove the upper door hinge (fig. 7 1, page 5).
➤ Carefully lift out the door.
➤ Remove the threaded pins (fig. 7 2, page 5).
➤ Pull the locking hook (fig. 7 3, page 5) off the rod.
➤ Remove the locking plate (fig. 7 4, page 5) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (fig. 7 3, page 5) back on the rod.
➤ Detach the top and bottom lock holders (fig. 7 5, page 5) on the left side.
➤ Detach the top and bottom door hinges (fig. 7 1, page 5) on the right
side.
➤ Fasten the top and bottom door hinges (fig. 7 1, page 5) to the left side.
➤ Fasten the top and bottom lock holders (fig. 7 5, page 5) to the left side.
26
Kühlschrank
EN