hillvert HT-MD-300B Manual De Instrucciones página 31

Starting engine
A more detailed description of the engine operation and all related precautions and procedures can be
found in the Engine Manual packed separately with the powered wheelbarrow. Follow the procedure
below for cold starts:
1. Turn choke lever on the engine to full choke position.
2. Set the throttle lever on the handlebar at halfway position.
3. Turn the engine switch on.
4. Pull the starting rope slowly several times to allow the gasoline to flow into the engine's carburetor.
Then hold the start handle firmly and pull rope out a short distance until you feel some resistance.
Then pull the rope smoothly and briskly, and allow rope to return gently. Do not let the rope snap
back. If necessary, pull the rope several times until the engine starts.
5. Allow the engine to run for several seconds to warm up. Then, gradually move chock lever to "OPEN"
position.
Restarting an engine that is already warm from previous running does not normally requires use of the
choke.
1. Set the throttle lever on the handlebar at halfway position.
Restarting an engine that is already warm from previous running does not normally requires use of the
choke. Hold the start handle firmly and pull rope out a short distance until you feel some resistance. Then
pull the rope smoothly and briskly, and allow rope to return gently. Do not let the rope snap back.
Operating
After engine warms up, pull throttle lever to accelerate engine speed.
Engage the required gear and slowly squeeze the clutch control lever. If the gear does not engage straight
away, slowly release the clutch lever and try again. In this way the powered wheelbarrow will start
moving.
The powered wheelbarrow has the steering levers on the handlebars and this makes steering very easy. To
turn right or left, simply operate the corresponding right or left steering lever.
The sensitivity of the steering increases in proportion to the speed of the machine and that with the empty
machine, a light pressure on the lever is all that is needed to turn. While when the machine is loaded,
more pressure is required.
The powered wheelbarrow has a maximum capacity of 300kg. However, it is advisable to assess the load
and adjust it according to the ground on which the machine will be used.
It is therefore advisable to cover such stretches using low gear and taking extra care. In such situations, the
machine should be kept in low gear for the whole stretch.
Avoid sharp turns and frequent changes of direction while driving on the road, in particularly on rough,
hard terrains full of sharp, uneven points with a high degree of friction.
Remember to be careful when working in adverse weather conditions(ice, heavy rain and snow)or on
types of ground that could make the powered wheelbarrow unstable.
When the clutch control lever is released, the machine will stop and brake automatically.
If the machine is stopped on a steep slope, a wedge should be placed against one of the wheels.
EN