Descargar Imprimir esta página

GE GFDS175 Manual Del Propietário página 11

Ocultar thumbs Ver también para GFDS175:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Instructions
m REMOVE
THE DOOR ASSEMBLY
A. Open the door to approximately Z30 degrees.
Ba
Remove the 6 tapping
screws located around
the perimeter of the door outlining
the gasket.
Remove the outer ring.
Ca
Remove 3 hinge screws starting at the bottom
and move up. Make sure the door is supported
while removing the screws.
-Then loosen top
screw, remove door
and remove screw
remove
three lower
hinge screws
D. Loosen the top screw as shown. Unhook the door
by lifting and pulling. Remove the top screw.
[]
REMOVE
HINGE AND
COVER
IMPORTANT: Note the location of the hinge (left or
right) before removing.
A. Remove the 6 machine screws from the hinge
and the 2 machine screws from the hinge cover.
Hinge
Cover
Hinge
B. With the screws removed, turn the door over and
separate the outer door assembly and hinge cover
of the door from the door frame and set aside.
FTI REINSTALL HINGE ASSEMBLY
A. Place the hinge in the opposite side of the door
as shown. Push the hinge in place until the hinge
holes align with the door holes.
Hinge shown
on opposite
side
11

Publicidad

loading

Este manual también es adecuado para:

Gfds170