GE GFDS175 Manual Del Propietário página 5

Control settings.
Quick Start
[i]Press the Power button.
If the screen is dark, a press
of the Power button will
"wake up" the display.
Power
r_ Normal
M xed Loads Towels
Select a dry cycle. (Defaults ore set c............ _o
for each cycle. These default , // B .......
settings can be changed. See ....
Bulky _IlWarm
Control settings for more ...... _ o_
information.)
Po,mP ...... Fluff
........ Qu_ck J_ _ T_......
Dry
F_ Press the Start/Pause button.
Start/Pause
GEAppliances.com
Power
press to "wake up" the display. If the display is active, press to turn the dryer off.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Dry Cycles
The dry cycle controls the length and tumble speed of the drying process. The chart below will help you match the dry
setting with the loads.
Normal/Mixed Loads For loads consisting of cottons and poly-blends.
Cottons For cottons and most linens.
Delicates For lingerie and special-care fabrics.
For large coats, bed spreads, mattress covers, sleeping bags, blankets, comforters,jackets, small rugs,
Bulky/Bedding and similar large and bulky items.
Clothing worn for active sports exercise and some casual wear. Fabrics include new technology
Perm Press/Casuals finishes and stretch fibers such as Spandex.Also for clothing labeled EasyCare or Perma Press:For
wrinkle-free and permanent press items.
Quick Dry For small loads that are needed in a hurry, such as sports or school uniforms. Can also be used if the
previous cycle left some items damp, such as collars or waistbands.
Towels/Sheets Use for towels OR sheets. It is not recommended to mix towels and sheets in the same load.
Steam Dewrinkle Provides 20 minutes of steam drying to assist with dewrinkling clothes. Ideal for loads left in dryer
Full Loads for an extended time.
Warm Up Provides 10 minutes of warming time to warm up clothes.
Air Fluff/No Heat Provides 10 minutes of tumbling time without heat.
Use to set your own dry time. Time Dry is also recommended for small loads. To use:
!. Turn dry cycle dial to Time Dry.
2. Increase the drying time by pressing the Add Time button.
Note: This button only increases the time. When max time is reached, pressing the button again
will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start/Pause.
Time Dry