Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Leveling
To protect property
and refrigerator
from
damage,
observe the following:
• Protect vinyl or other flooring with cardboard,
rugs,
or other protective material.
• Do not use power tools when performing
leveling
procedure.
To enhance the appearance
and maintain
performance
the refrigerator
should be level.
Note
• Complete
any required door reversal, panel
installation
and/or a water supply connection,
before leveling.
Materials
Needed:
• %" hex head driver
• Carpenter's
level
1. Remove toe grille.
• Grasp firmly and pull outward
to unclip.
2. Remove bottom hinge cover(s).
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
Notch
Location
• Use slight pressure to pry the
cover loose.
• Continue to maintain
downward
pressure to the
notched side of the cover while
swinging
it off.
3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
.
C
C
Using the hex head driver, turn each of these
adjustment
screws (B) to raise or lower the rear of
the refrigerator.
Using the carpenter's
level, make sure front of
refrigerator
is '/4" (6 ram) or '/2bubble higher than
back of refrigerator
and that the refrigerator
is level
from side to side.
6. Turn stabilizing
legs (C) clockwise
until firmly
against floor.
7. Turn adjustment
screws (A) counterclockwise
to
allow the full weight of the refrigerator
to rest on
the stabilizing
legs.
8. Replace hinge cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
9. Replace the toe grille.
Note
• For proper reinstallation,
ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting
clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Publicidad
