Publicidad
Idiomas disponibles
Idiomas disponibles
Installation / Electrical
DISCHARGE PIPE CONNECTION
(FIGURE 3)
Connect the 5-way tank tee to your plumbing system.
Snifter Valve
Flow
1" Pipe To
Household
Water System
Priming
Port
Discharge
Port
Flow
Priming
Check Valve
Tee
(Purchase
Separately)
1" Pipe From
Water Source
Water Level
Foot Valve
Figure 3 – Suction and discharge connections for Model
EP2-04. For Models EP2 and EP4, connect suction piping
as shown. Connect discharge port of pump directly to
household plumbing system.
Tank
5-Way Tank Tee
Pressure
Gauge
Pump Intake
Port
4555 1005
ELECTRICAL
Hazardous voltage. Risk of dangerous or
fatal electric shock. Plug the pump into a 220 Volt, 50
Cycle, grounded outlet only. For instructions on wiring
the pump, refer to the decal inside the control box. Do
not modify or remove the plug. Make sure the pump cir-
cuit meets all codes and ordinances that apply. To avoid
dangerous electrical shock hazard, keep the cord dry at
all times.
Lubrication
The motor is lubricated at the factory for the life of
the bearings. The pump seal is water cooled and self
lubricating.
Pump Service
Hazardous voltage. Can shock, burn, or
cause death. Unplug the pump before servicing it. Do not
handle the pump or attempt to work on the pump with
wet hands or while standing on a wet or damp floor.
The motor has an auto-reset thermal overload protector.
Pressure
Switch
If the motor overheats, the overload will cut off the
power to prevent damage and will reset after the motor
cools. If the overload trips repeatedly, check the pump
for the cause (low voltage, a clogged impeller, etc.).
4
Publicidad
