JVC KD-T915BTS Manual De Instrucciones página 37

Audio Settings
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE ] is set to [2-WAY]) (page 30)
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier (Page 47)
KD-T915BTS/KD-T91MBS:
Setting on
[SPK/PRE OUT]
FRONT
[REAR/REAR] (default) Front speakers
output
[SUB.W/SUB.W] Front speakers
output
KD-T910BTS/KD-TD91BTS/KD-SR86BT:
Setting on
[SPK/PRE OUT]
[REAR/REAR] Front speakers output
[REAR/SUB.W] (default) Front speakers output
[SUB.W/SUB.W] Front speakers output
Audio signal through lineout terminal
REAR
Rear speakers output Subwoofer output
L (left): Subwoofer output Subwoofer output
R (right): (Mute)
Audio signal through lineout terminal
FRONT REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
KD-T711BT/KD-T710BT/KD-TD71BT:
Setting on
[SPK/PRE OUT]
[REAR/REAR]
[REAR/SUB.W] (default) Subwoofer output
[SUB.W/SUB.W]
Connection via speaker leads
You can also connect the speakers without using an external amplifier
but still being able to enjoy the subwoofer output with these settings.
SW
(Page 46)
Setting on
[SPK/PRE OUT]
[REAR/REAR]
[REAR/SUB.W]*
[SUB.W/SUB.W]
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
(Page 33)
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION R15] to
[POSITION 00]. (Page 30)
* Except for KD-T915BTS/KD-T91MBS.
Audio signal through lineout terminal
REAR/SW
Rear speakers output
Subwoofer output
Audio signal through rear speaker lead
L (left)
Rear speakers output Rear speakers output
Rear speakers output Rear speakers output
Subwoofer output
R (right)
(Mute)
31
ENGLISH