Oase Home Instrucciones De Uso página 19

Operating conditions indicated by the Status LED
LED colour LED status
– Off
Green Lit
Flashing slowly
(1× per second)
Yellow Lit
Flashing fast
Flashing slowly
(2 s on, 1 s off)
Red Flashing
Service button functions
Operation
Press and hold for 5 seconds until
the status LED begins to flash in
green.
Press and hold for 15 seconds until
the status LED begins to flash
quickly for the second time (after 5
seconds it will flash for the first
time, see above).
Description
The Garden Controller Home, Cloud is switched off.
A direct connection is established.
A connection to a WiFi network is established.
The Garden Controller Home, Cloud starts or is in firmware update
mode.
A firmware update is in progress.
The Garden Controller Home, Cloud is attempting to establish a con-
nection to the router. This can take several minutes.
• If no connection is found, check the WiFi connection. If necessary,
reduce the distance between the Garden Controller Home, Cloud
and the router.
An internal error has occurred; recommended procedure:
• Disconnect the power supply, wait for approx. 10 seconds, then re-
establish the power supply.
• If the error remains active, ...
− use the "OASE Control" app to check for new firmware. If neces-
sary, install new firmware.
− reset the device to its factory settings and restart it. (→ Service
button functions)
− contact the OASE service.
Description
Resetting the network settings
• The network settings are reset to the delivery default settings.
• All other settings are maintained (e.g. device list and device set-
tings).
• During resetting, the status LED first flashes quickly in green, then
lights up in yellow.
Reset to factory default settings
• All settings are reset to the delivery default settings.
• During resetting, the status LED first flashes quickly in green, then
lights up in yellow.
EN
19