Oase Cloud Puesta En Marcha página 14

Installation
WARNING
The power supply carries dangerous electrical voltage and must not be placed directly near wa-
ter. Otherwise, there is a risk of serious injury or death from electric shock.
Install the power supply in a flood-protected position at least 2 m from the water.

 A, B
Connection
Connecting an OASE Control-compatible unit
On OASE Control-network ...
• may consist of a max. 10 units.
• may be max. 100 m long.
OASE Control-Connection cables of the following lengths are available as accessories:
2.5 m (article number 47038), 5 m (47039), 10 m (47040) and 30 m (72713)
• must end at the last unit with the OASE Control-terminal resistor (R).

More information on OASE Control is available at www.oase.com in the "Smart garden con-
trols and lighting" section.
Connecting
NOTE
The unit will be damaged if water enters a connection.
 The rubber seal of the plug connector must be clean and must fit exactly.
If the rubber seal is damaged, it must be replaced. If the connection is disconnected, an older

rubber seal (> 2 years) must be replaced.
Always secure the plug connection with 2 screws.

 C
Connecting the power pack
 D
14