Publicidad
Idiomas disponibles
Idiomas disponibles
Eyelet Pliers with 100 Round Eyelets, 5 mm
1 Punch
2 Depth stop
3 Knurled screw
4 Press pieces
5 Round eyelets
INTENDED USE
These pliers are used for punching the material into which the eyelets are inserted and for pressing
the 5 mm eyelets that are included.
SAFETY INFORMATION
•
Use the tool for the intended purpose only.
•
Check the tool before using and do not use the tool if parts are missing or damaged.
•
Keep children and other unauthorised persons away from the work area.
•
Do not ever let any children play with the tool or the packaging.
•
Be sure to protect your hands during use!
•
Do not hold your hands between the pliers during use.
USE
Punch
Before inserting an eyelet, a hole must be punched into the material.
The required hole is punched for the eyelet using the punch.
Depth stop
With the depth stop, the necessary side clearance of the perforation from the edge of the material is
adjusted. Use of the depth stop is advantageous especially when setting eyelets one after another.
(Perforation at equal distance)
Loosen knurled screw, adjust depth by moving the stop and fix with the knurled screw.
Press pieces
Position the material with the inserted eyelet between the press pieces.
Make sure that the hole of the eyelet is centred on the guiding pin of the press piece.
When operating the pliers, ensure the proper seating of the eyelet and apply pressure to the pliers
once completely to the stop.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
569
@
o f n i
: l i
Publicidad
