Cleaning Device; Do Not Boil Or Put In Autoclave The Accessories - Gima FLO EOLO Manual De Istrucciones

~
Hz
I
O
Use a soft dry cloth with not – abrasive and not – solvent detergets.
MAKE SURE THAT INTERNAL PARTS OF THE APPLIANCE DON'T COME INTO CONTACT WITH
LIQUIDS AND THE PLUG IS NOT INSERTED
Procced as follows to disinfect the accessories:
1. Turn the upper part of the nebulizer in an anti-clockwise direction;
2. Disconnect the internal pisper at the base of the nebulizer using the fingers;
3. Use denatured alcohol or a hypochlorite - based solution, easily found at chemist, to clean the
accessories;
4. After using the appliance, disassemble the nebulizer and clean all parts in warm water, rinse carefully
and remove excess water using a soft cloth and leave to dry in a clean place.

DO NOT BOIL OR PUT IN AUTOCLAVE THE ACCESSORIES

After each treatment clean thoroughly each component of the nebulizer (except air tube) removing medication
residual and possible impurities. Clean all parts in warm water.
Rinse thoroughly making sure that all deposits are washed away and let dry.
Guidance and manufacturer's declaration – Electromagnetic Emissions
(as request by regulation EN 60601-1-2:2001)
The EOLO aerosol is intended for use in the electromagnetic environment specified below.
CE marking in conformity with EC directive 93/42/EEC
Warning, consult the instruction manual
To Preserve in place coolness and dry land
Conservation temperature: -25 ÷ 70°C

CLEANING DEVICE

CELANING THE ACCESSORIES
13
Class II isolation equipment
Type B equipment
Fuse
Alternate Current
Mains Frequency
ON
OFF