Fracarro FRPRO 10 Instrucciones De Funcionamiento página 36

CONTROL
UNIT SETUP
Setting the access
PIN (default 1234)
Setting the LCD
contrast.
Accepted values 0...
15
Load/Save
configuration from/to
USB
Setting the
serial port speed
Reading the installed
software version
Default Reset:
restore the unit to the
factory settings
From the "CONTROL UNIT" menu, it is possible to change the menu language, set the user code, modify
the LCD contrast, save the Profiler unit configuration in a USB pen drive, load the configuration from the
USB pen drive, change the communication speed of the serial port (we recommend 57600 bps), check the
software version of the Profiler unit, and reset the unit to the default settings.
5.2 HEADEND UNIT MENU
Select language from the
programming menu
CONTROL UNIT
LANGUAGE
LANGUAGE
Italiano
LANGUAGE
English
CONTROL UNIT USER CODE
YES
USER CODE
USER CODE
NO
LCD CONTRAST
CONTROL UNIT
0
LCD CONTRAST
LCD CONTRAST
15
USB
CONTROL UNIT
STORAGE
USB STORAGE
LOAD
USB STORAGE
SAVE AS
CONTROL UNIT SERIAL SPEED
115200 bps
SERIAL SPEED
SERIAL SPEED
9600 bps
CONTROL UNIT .
SOFTWARE VERSION
SOFTWARE
version
VERSION
Default Reset?
CONTROL UNIT
DEFAULT RESET YES=V / NO=X
36
Italiano
Francais
To select
Espanol
Portuguese
Deutsch
English
Enter code Re-enter code
**** ****
Code disabiled
To select
LOAD
Enter USB
Press DOWN to
YES=V / NO=X
scroll down the
files
SAVE AS
Enter USB
Configuration1
YES=V / NO=X
9600 bps
19200 bps
To select
38400 bps
57600 bps (default value)
115200 bps
LOAD
Configuration1
SAVE AS
Saving OK
5.2
To c
lang
Ger
5.2
To e
CO
NO
•
•
•
•
•
c
5.2
c