Fracarro FRPRO 10 Instrucciones De Funcionamiento página 45

FR PRO can be downloaded from www.fracarro.com.
Minimum requirements for the system:
• Dotnet Framework v.2 or later
• Windows XP Service Pack 2 or later (Windows Vista and 7)
Using the FRPRO software, you can create a configuration of the clusters (initial channel and end channel,
channel type, cluster level, etc.) and of the other inputs by working from the computer. The configuration file
will be saved in a USB pen drive and then it will be loaded into the Profiler unit and/or a copy of the configu-
ration can be saved onto the hard disk.
Use the Print function to print the configuration.
Note:
To program the Profiler, you can neglect the settings relevant to the input and output levels as the Profiler
unit is equipped with the self-alignment function that automatically sets these gain values in order to equalize
the level of all clusters by optimizing the noise figure and the output level of all signals. See paragraph 5.4.
After launching the FR PRO software, set the product model that you want to program. Select the "File -
New" menu and choose the product model you want to program from the pop-up window.
The following is a description of the FR PRO software window:
this
V in
ext
will
set-
FM input gain Regolazione guadagno
adjustment ingresso FM
6. PROGRAMMING SOFTWARE
LED to show that the voltage is
Led di indicazione di abilitazione
enabled for the UHF input
della tensione per ingresso UHF
B.III+DAB input gain Regolazione guadagno
Setting the clusters on the Impostazione dei cluster
ingresso B.III+DAB
adjustment
Association of the clu- Associazione dei cluster
agli ingressi UHF
sters to the UHF inputs
AUX input gain
Regolazione guadagno
ingresso AUX
adjustment
sulla banda UHF
UHF band
45
SAT input gain adjustment and Regolazione guadagno ingresso
tilt adjustment (for FR PRO10S SAT e regolazione pendenza
(solo per modello FR PRO10S)
model only)