GE 26 Manual Del Propietario Y Instalación página 21

Installation Instructions
[] REPLACING THE REFRIGERATOR DOORS
(cont.)
r_ Insert the top hinge pin into the hinge hole on top
of the refrigerator door. IVlakesure the door is aligned
with the cabinet and opposite door. Attach the hinge
to the top of the cabinet. Do not tighten bolts
completely.
\
rE1 Onleft-handdoors,passthe wiresand waterline
throughthe top hingepin.Thenconnectthe waterline
and two connectors.
rF1 Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
r_ IVlake sure the gasket on the door is flush against
the cabinet and is not folded. IVlake sure the door is
straight and the gap between the doors is even across
the front. While holding the aligned door in place,
tighten the top hinge bolts.
r_ Reconnectthe two connectors at each side of the top
cap and reattach the three Phillips-headscrews on top.
f.
[] REMOVE THE FREEZER DOOR
r_ Pullthe freezer door open to full extension.
rB] Removethe freezer bin by pulling both brackets upward
at the same time. (Seepage 19.)
r_ Take out the lower basket by lifting the basket up from
the rail system. (Seepage 19.)
r_ Removethe two 10 mm hex-head bolts from the right
and left side.
21