GE 26 Manual Del Propietario Y Instalación página 4

About the control with temperaturesettings
(Hold 3 sec
for Turbo Freeze)
)Hold 3 sac
to Reset Filter}
TURBO FREEZE TURBO COOL I '_l'r"_' I
Li ht
OH/O_
(H_d 3 seconds)
(Hold 3 sec
for Turbo Cool)
RESET F}LTER CUBED CRUSHED WATER
(Hold 3 sec
to Lock Control}
NOTE:Therefrigerator is shipped with protective film covering the temperature controls. If this film was
not removed during installation, remove it now.
The temperature controls are preset in the factory at 38°F for the refrigerator compartment and -2°F for
the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.
The temperature controls can display both the SETtemperature as well as the actual temperature in the
refrigerator and freezer.Theactual temperature may vary slightly from the SETtemperature basedon usage and
operating environment.
ADJUST
REFRIGERATORJ
{Hold 3 sec
for TurboCooi)
ADJUST
FREEZER
{Hold 3 sec
for Turbo Freeze)
Changing the Temperature
To change the temperature, press and
release the ADJUST FREEZER or ADJUST
REFRIGERATOR pad. The display will
show the actual temperature. To change
the temperature, tap either the ADJUST
FREEZER or ADJUST REFRIGERATORpad
until the desired temperature is displayed.
Once the desired temperature has been
set, the temperature display will return
to the actual refrigerator and freezer
temperatures after !0 seconds. Several
adjustments may be required.
Eachtime you adjust controls, allow
24 hours for the refrigerator to reach
the temperature you have set.
4