RIDGID R09894 Manual Del Operador página 13

MAINTENANCE
REQUIRED DAILY CHECKLIST
 Remove the battery pack from the tool and remove all
fasteners.
 Check all screws, nuts, bolts, and pins on the tool. If any
of these are loose, they must be tightened with the ap-
propriate size wrench.
 Press the workpiece contact against a workpiece to
ensure that it moves smoothly.
 With the workpiece contact depressed, pull the trigger.
The trigger should move smoothly, without binding.
 Select the full sequential actuation mode ( ).
 While the tool is not loaded, insert the battery into the
tool.
 Begin inspection:
• Press the grip switch to activate the nailer.
• Without pulling the trigger, press the workpiece contact
against a workpiece several times. The tool must not
actuate.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away and pull the
trigger several times. Hold the trigger in this position
for a minimum of 5 seconds The tool must not actuate.
• Load fasteners, then press the workpiece contact firmly
against the workpiece and pull the trigger. The tool must
actuate.
• With the workpiece contact still depressed, release the
trigger. The driver must return to its up position.
 Remove the battery pack and remove all fasteners.
 Select the contact actuation mode (
 Place the battery pack in the tool.
 Begin inspection:
• With the workpiece contact not engaged on the
workpiece, point the tool down and away. Pull the trig-
ger. The tool must not actuate.
• Load fasteners, then fully depress the trigger and push
the workpiece contact against a workpiece. The tool
must actuate.
 Remove the battery pack and remove all fasteners.
 If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool to
operate in the manner that best fits your application.
 Set the depth of drive according to the Depth-of-drive
Adjustment section in this manual.
 Place the battery pack in the tool and load the proper
fasteners for the desired application. Repeat this checklist
before using the tool each day, or if the tool is dropped
or damaged in any way.
13 – English
).