Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - Sure-Lites APC7RG/APCH7RG/APXH7RG/APC7RGSAL Exit and
Emergency Light Combo
DETERMINE CONFIGURATION / ASSEMBLE
FIXTURE
1.
The APC series combo and APXH7 exit can be
configured for wall, ceiling, or end mounting. The
mounting method will determine where the heads can
be mounted.
2.
Remove the exit sign stencil from the exit frame to
access the inside of the exit sign.
3.
If ceiling or end mounting, remove the appropriate hole
plug and snap in the canopy by sliding it in the keyhole
opening. Place the canopy nose through the mounting
hole until the side of the frame touches the canopy.
Lock the frame onto the canopy by sliding the frame
in a direction parallel to the canopy length toward the
narrow end of the mounting hole. Slide the frame until
both snaps engage the canopy nose preventing any
motion back out of the hole. See Figure 1.
4.
Select the mounting locations for the heads. Remove
the appropriate hole plug or slot covers. See Figure 2.
5.
Feed the wires for the heads through the mounting
holes and then snap the heads into place.
6.
Route the wires from the heads to the LED PCB. There
are wire harnesses coming from the circuit board with
keyed connectors that will mate with the connectors
from the heads.
(APC only)
REMOVE PLUG TO
MOUNT HEAD IN
THESE LOCATIONS
Figure 2
2
COOPER LIGHTING SOLUTIONS
FIGURE 1
HOLE PLUG -
REMOVE FOR END MOUNT
FIGURE 2
REMOVE SLOT TO MOUNT HEAD
IN THESE LOCATIONS
IB50510123
Installation Instructions
CANOPY
HOLE PLUG -
REMOVE FOR END MOUNT
Figure 1
REMOVE HEADS FROM
CARDBOARD RETAINER
REMOVE PLUG TO
MOUNT HEAD IN
THESE LOCATIONS
REMOVE 4 TABS
TO OPEN SLOT
MOUNTING PLATE
CANOPY
HOLE PLUG -
REMOVE FOR
CEILING MOUNT
MOUNTING PLATE
CANOPY
REMOVE HEADS FROM
CARDBOARD RETAINER
REMOVE SLOT TO MOUNT HEAD
REMOVE 4 TABS
IN THESE LOCATIONS
TO OPEN SLOT
Publicidad
