LG CRD-8360B Manual De Usuario página 8

WHEN USING A SECONDARY CONTROLLER
* If your PC has an additional IDE controller on the motherboard or on a system slot, each
IDE device connected to the secondary IDE controller must also be set to the Master or
Slave mode. If you are connecting your CD-ROM drive to a secondary IDE card, and it
is the 1st device you are connecting to it, then set the CD-ROM jumper to the Master
position. If it is the 2nd device, set the CD-ROM jumper to the Slave position.
* Depending on the IDE card and whether the CD-ROM drive is a master or slave
unit, the diagram below represents the different ways in which the CD-ROM may
be configured in your PC. The table below the diagram shows the possible Jumper
placements that would correspond to each of the different configurations shown.
Secondary IDE Channel
Secondary Master
(Hard Disk or
CD-ROM Drive)
If you have the system with two IDE channels (in the case of an enhanced IDE PC),
do not install an IDE controller card in your system.
IDE Controller
Primary (1st IDE card)
Secondary (2nd IDE card)
Secondary (2nd IDE card)
PC Manual says use CSEL
Secondary IDE
Controller CARD
Hard Disk Controller Card
(This card may be a connector on the Motherboard)
Secondary Slave
(Hard Disk or
CD-ROM Drive)
Figure 5. Possible System Configuration
CD-ROM Connection
Slave(Hard disk is Master)
Master(1st device on 2nd IDE Card)
Slave(2nd device on 2nd IDE Card)
Card Slot
Motherboard
E-8
Primary IDE Channel
Primary Slave Primary Master
(Hard Disk or (Hard Disk for
CD-ROM Drive) Boot-up)
Jumper Placement
SLAVE (default)
MASTER
SLAVE (default)
CSEL