Athena GET SX1 CONTROLLER Guia página 4

C. SX1 CONTROLLER INSTALLATION
REMEMBER TO WORK IN SAFE CONDITIONS AND TO KEEP THE ENGINE
TURNED OFF.
1.
Remove
combined switch and install
SX1 CONTROLLER
handlebar.
2.
Connect the SX1 CONTROLLER
connector to the connector on the
"MAIN" cable of the GET control
unit.
AT TENTION:
-To connect the SX1 CONTROLLER control unit and the SX1 CONNECT simultaneously, use the GL-
264-AA harness included in the SX1 PRO control unit kit.
-Always make sure that the connectors are correctly associated; you will hear a "click" when you hook
them together, and that will tell you they are correctly connected.
-Make sure that the free movement of the handlebar in both directions is not hindered, and that the
product never hinders or interferes with the moving parts of the motorbike or with the rider.
the original
on the
CONTROL UNIT
4
SX1 CONTROLLER
EN