Athena GET SX1 CONTROLLER Guia página 6

GPA TRACTION CONTROL SETTINGS*
There are 10 customizable GPA intervention levels available for both maps.
To change the GPA intervention level, press the map selection buttons until the desired level is
reached:
the
corresponds to the set
GPA level
To exit GPA level settings mode, simply do not press any buttons for approximately three seconds.
Once you exit settings mode, you can check the set GPA level by pressing the activation button
briefly: the number displayed will correspond to the set GPA level.
For beginners, a good suggestion to find the ideal GPA level setting (which can be totally different
from pilot to pilot) would be to start riding at level 10 and then decrease the GPA assistance level until
you reach the one that is most suitable for you.
To set the GPA intervention level, first choose the desired mapping (MAP 1 or
MAP 2), then press the GPA activation button highlighted at the bottom left for
approximately two seconds until a flashing GREEN number appears.
When the function is active, the LED will also light up in GREEN.
number displayed
6
a green letter H will be
displayed only for level 10.
EN