Publicidad
Idiomas disponibles
Idiomas disponibles
aluminum f oil,oranybuildup o fmetallic particles should b ekept a way from charger
cavities. Always u nplug t hecharger from thepower s upply w hen there isnobattery
pack inthecavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze orimmerse charger inwater oranyother l iquid.
z_WARNING:
Shock hazard. Do not allow any liquid to get inside charger. Never
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
Safety
Warnings
and Instructions:
Drills
WARNING:
Before using tool, read all instructions and cautionary markings on tool.
WARNING:
Drill may stall (if overloaded or improperly used) causing a twist.
Always expect the stall. Grip the drill firmly with two hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
FUNCTIONAL
DESCRIPTION
Figure A
1. Trigger Switch
2. Forward/Reverse
Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
Operating
instructions
Installing
and Removing
the Battery
Pack From the Tool
z_ CAUTION:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO iNSTALL BATTERY PACK: Insert
battery pack (6) firmly into tool until an
audible click is heard as shown in Figure B.
Ensure battery pack is fully seated and fully
latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button (7) as shown in
Figure C and pull battery pack out of tool.
Publicidad
