Publicidad
Idiomas disponibles
Idiomas disponibles
Trigger
Switch
& Forward/
Reverse
Button
= Figure
D
• The drill is turned ON and OFF by pulling
and releasing the trigger switch (1) shown
in Figure D. The farther the trigger is
depressed, the higher the speed of the
drill.
• A forward/reverse
control button (2)
determines the rotational direction of the
toot and also serves as a lock off button.
• To select forward rotation, release the
trigger switch and depress the forward/
reverse control button on the right side of
the tool.
• To select reverse, depress the forward/
reverse control button on the left side of
the tool.
• The center position of the control button
locks the tool in the off position. When
changing the position of the control
button, be sure the trigger is released.
Adjusting Torque Control
- Figure E
This tool is fitted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws.
Large screws and hard workpiece materials
require a higher torque setting than small
screws and soft workpiece materials.
• For drilling in wood, metal and plastics, set
the collar to the drilling position symbol M
• For screwdriving, set the collar to the
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque setting.
• Tighten the first screw.
• If the clutch ratchets before the desired
result is achieved, increase the collar
setting and continue tightening the
screw. Repeat until you reach the correct
setting. Use this setting for the remaining
screws.
Dual Range
Switch
= Figure
F
The dual range feature of your drill allows
you to shift gears for greater versatility.
• To select low speed, high torque setting
(position 1), turn toot off and permit to
stop. Slide gear shifter button (4) away
from the chuck.
• To select the high speed, low torque
setting (position 2), turn toot off and
permit to stop. Slide gear shifter button
back toward the chuck.
NOTE: Do not change gears when tool is
running. If you are having trouble changing
gears, make sure that the dual range gear
button is either completely pushed forward
or completely pushed back.
@
Publicidad
