KPC KL 310-3V Libro De Uso Y Mantenimiento página 21

IDENTIFICATION AND TECHNICAL SPECIFICATIONS
ATTENTION: FOR THE ENGINE TECHNICAL SPECIFICATIONS, SEE THE ENCLOSED OWNER'S MANUAL OF THE ENGINE.
•
Acoustic power level LwA = from 92 dB (A) to 105 dB (A)
•
Noise level at operator's ear : LpA = from 81 dB (A) to 90 dB (A)
•
Test condition: 1,6 mt at the centre of the handlebar
• Handlebar vibration according to ISO 1033: value from 4,76 m/sec² to 7,00 m/sec²
CHARACTERISTICS OF ALL THE ENGINES FITTED:
• Exhaust guard
•
Recoil starter
•
ENGINE LUBRICATION: see the owner's manual of the engine
• Engine oil quantity: see the owner's manual of the engine
•
Engine fuel: unleaded petrol
•
Safety device for both forward and backward gear stopping the tiller.
•
The gear has got two forward speeds and one reverse, a belt joins the transmission to the engine and an oiled chain to the tiller.
SPECIFICATIONS WITH ENGINE RUNNING AT 3200 RPM
I forward = 82 rpm
II forward = 113 rpm
Reverse = 61 rpm
• Speed gear in oil bath
•
Belt clutch with tightener
•
Tiller with hexagonal shaft and reinforced blades
•
Guidance handlebars can be adjusted in many positions (vertical and side adjustment).
•
The tiller is 80 cm wide.
•
The spur is adjustable
APPLICABLE ACCESSORIES
•
Ridger with attachment
•
Thin iron wheels (Ø 320) are suitable when using the ridger
CE MARK
To identify the machine (serial number, engine, weight, power) have a look at the number plate put on the machine as in (Picture 1 Ref. "A").
TILLING UNITS:
The blades are adjustable and provided with a protection mudguard. In picture number 2 you can see the possible working width: 60 – 80 cm with
the extensions and the side plates fitted.
DIMENSIONS
The dimensions of the tiller are shown in picture 3.
KL 310-3V
21