Publicidad
9
CHANGING TABLE ASSEMBLY - MATTRESS PAD ASSEMBLY
9a. Place the Mattress Pad (15) on its side, on the
changing top/top shelf. Position the straps on the
back of the mattress pad over the insertions provided
on the top shelf.
9b. Position the Nuts (D2) on the insertions below the top
shelf. Position the Washers (C) over the insertions on
the top shelf.
9c. Attach the Bolts (D1) in the insertions provided on the
strap fixing the mattress pad to the top shelf.
9d. Insert the assembled drawer in the slots of the top half
of the changing table as shown in the illustration.
RESTRAINT HARNESS SYSTEM USE:
• Place the infant on the changing table's mattress pad.
• Position the restraint harness over the middle of the
infant's torso and insert the buckled ends into each
other until they lock shut with a click.
• Gently pull the loose ends of the strap to lightly snug
the restraint harness around the infant.
MAINTENANCE:
• Check fasteners periodically for tightness.
• Do not over-tighten. This may cause distortion or
breakage.
FALL HAZARD:
• Always keep the child within arm's reach.
• Always use a restraint belt to prevent falls.
• Always secure the pad to the changing surface using a
bolt & nut and washer.
D1
Bolt M6 X 20mm (x2)
Boulon M6 X 20mm (x2)
Perno M6 X 20mm (x2)
22
D2
C
Nuts (x2)
Washers (×2)
Noix (x2)
Rondelles (×2)
Nueces (x2)
Arandelas (×2)
15
(D1)
(C)
(C)
(D2)
(D2)
15
(D1)
By
Publicidad
