Publicidad
Idiomas disponibles
Idiomas disponibles
3. Rotation Speed Mode
This feature changes the rotating speed of the laser.
Press the
button to change the rotating speed from the default
RPM
RPM
600 rpm to 1200 rpm, 0 rpm, 100 rpm, or 300 rpm. Each time
this button is pressed, the rotating speed cycles through the rpm
settings.
NOTE:
• When starting the unit, the laser will rotate at 600 rpm.
• A lower speed (0 - 300 rpm) is recommended for indoor use to
give the best beam visibility.
• A higher speed (600 - 1200 rpm) is recommended when used with
a detector.
4. Point/Line Segment Mode (Scan Mode)
This feature changes the 360° rotating laser to either a line segment
laser or a single laser point.
1.
To change from a 360° rotating laser to a laser point or line,
press the
is working in either Automatic or Manual mode. Each time this
button is pressed, the laser will cycle successively from 15°, 30°,
60°, or 0°.
2. In Point/Line Segment mode, press
position of the laser line clockwise or press
the position of the laser line counterclockwise.
3. Press the
16
button. This can be done when the rotary laser
button to exit Point/Line Segment Mode.
RPM
RPM
button to adjust the
button to adjust
©2023 Johnson Level & Tool
Publicidad
