coralwai ZEYA Manual Del Usuario página 28

PE pipe connection.
When connecting, remove the Ω-type fixed snap ring, cut the corresponding PE pipe
and insert it into the lower part of the joint. Pull out slightly, ensure that the PE pipe is
inserted into the joint, and then install the Ω-type retaining ring.
1
Clamping ring
blue "Ω" type
Connector
4
Slightly pull outward
the ring
When disassembling, remove the Ω-type clamping ring. After the protruding part
pushes against the joint, press the protruding part to pull out the PE line. Be careful not to
pull the PE line with force.
1
Connector installed
3
Press the ring in
2
Remove the retaining
ring type blue
"Ω" type
5
Assemble the blue ring Ω"
type retaining ring
2
Remove the fixed "Ω" clamping ring
4
Grasp the plastic ring and remove
the PE pipe
28
3
Fit the the PE pipe
EN