coralwai ZEYA Manual Del Usuario página 30

6.3.9 It has three positions:
The machine supplies two types of water. Pure water (only passes through the
PCT filter) and osmosed water (passes through filter and membrane).
1. When looking at the display from the front, with the handle facing forwards,
it dispenses pure water (only passes through the PCT filter).
2. With the handle in the opposite position, it dispenses osmosed water (filter
and membrane). In the middle position, it remains closed (See Figure 5).
3. When the tap is opened forwards, the display shows the TDS (Figure 6).
When the tap is closed, the display will turn off after 10 seconds (Figure 7).
When the tap is opened for filtered water, the display will not come on.
The filter bar will be white in normal use.
When the filter life is exhausted, it will light up in permanent red (Figure 8).
If the image shows "FAULT", the tap display shows E1 (Figure 9).
Hand
board
Position
washer
nut
tap
connection
In operation
P6
6.4 Drain connection. Connect a PE pipe of suitable length to the DRAIN connector
of the host unit and connect the other end to the drain pipe.
6.5 Pressure test: open the water supply, turn on the power, turn off the tap, check
for leaks at the joints after 5 minutes.
6.6 Instructions: Turn on the water source, turn on the power, the unit will start
producing water. If so, the machine is ready for normal use.
Clean water
connection
intelligent
faucet line
white pipe
blue pipe
drinking
water
Off Filter replacement
P7
30
Pure water
P8
Screen
Osmosis
water
Fault
P9
EN