Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE COOKTOP TO THE GAS SUPPLY
The gas connection fitting (fig. 2.1) is made up of:
•
the floating nut;
•
the elbow;
•
the gaskets;
The gas connection must be carried out by an authorised person according to the
relevant local standards.
•
If using a flexible hose, make sure it does not come into contact with moving parts.
•
The rear of the chassis is recessed to provide a channel for the appliance inlet pipe.
•
The gas connection fitting can be turned in the direction required (but never in a vertical
or horizontal position) after loosening the elbow and floating nut connection.
•
Never attempt to turn the elbow without having first loosened the floating nut.
•
The supplied gaskets guarantee a good seal for the gas connection. We recommend
that you replace the gaskets on the slightest sign of wear, deformation or imperfection.
•
After connecting to the gas mains, check that the couplings are correctly sealed, using
soapy solution, but never a naked flame.
ISO 228-1 (female)
1/2" G cylindrical
Conical pipe
IMPORTANT!
The conical pipe fitting must be used
only if requested by the applicable
local regulations.
If this conical adaptor is not supplied
with the appliance it can be
purchased by contacting the After-
Sales Service.
ISO 7-1 (male)
1/2" G conical
ISO 228-1 (male)
1/2" cylindrical
Elbow
ISO 228-1 (male)
1/2" cylindrical
Gasket
Fig. 2.1
Gasket
Floating nut
Appliance
inlet pile
Rigid pipe or
flexible hose
15
15
Publicidad
