Kenmore 79036673400 Instrucciones De Instalación

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUAUNED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed exactly, a fire or
exp!osion may result causing property damage, personal injury or death.
FOR YOUR SAFETY:
-- Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
-- WHATTO DO IFYOU SMELLGAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Fottow the
gas suppJier's instructions.
• tf you cannot reach your gas supplier, call the fire department.
-- Installation and service must be performed by a qualified installer, service
agency or the gas supplier.
Appliances
installed in the
state of Massachusetts;
This Appliance can only be
installed in the state of
Massachusetts by a
Massachusett's licensed
alumber or gasfitter.
This appliance must be installed
with a three (3) foot / 36 in_
long flexible gas connector
A"T" handle type manual gas
valve must be installed in the
gas supply line to this
appliance.
Do not pinch the power supply cord or
the flexible gas conduit between the
range and the wall
Do not seal the range to the side
cabinets
*NOTE: 30" (762 cm) minimum
clearance between the cooktop and the
bottom of the cabinet when the bottom
of wood or metal cabinet is protected by
not less than 1/4" (064 cm) flame
retardant millboard covered with not less
than No_ 28 MSG sheet metal,
0015 "(0.4 ram) stainless steel,
0.024"(0.6 ram) aluminum, or 0020"
(0_5 ram) copper_
36" (91 _4 cm) minimum clearance when
the cabinet is unprotected
, NOTE:
Allow at least
19 ¼" (48,9 C
cm) clearance
for door
1 s/16" optional side panels (see figure on left corner) i"_
(3.33cm) and dear wide cooktop rim as shown in the 6" x 6" (lS.2 cmx lS.2 crn)-
Recommended area for wall
"Countertop Preparation" section (see page 3). connection of pipe stub shut off
B 4_ Side panel
** For cutouts below 22 7/8"(58.1 cm),
appliance will slightly show out of the cabinet
***
IMPORTANT:
For width cutout (F dimension)
more than 30 1/15" (76.4 cm) to avoid damage
to the cooktop, make sure the appliance is
centered in the counter
opening while pushing
into it. Raise leveling legs at maximum position,
insert the appliance in the counter and then
level, Make sure the unit is supported by the
leveling legs and not by the cooktop itself.
Figure 1
22 7/8" **
(58.1 cm) rnin.
-_ _-1 1/8"
(2,86 cm)
FRONT
OF
CABINET
A HEIGHT, &WIDTH C, DEPTHTO F CUTOUT G, CUTOUT DEPTH H HEIGHTOF
! FRONT OF RANGE VVIDTN I £OUNTERTOP
35 318" (90 cm) - 36 318" (92 cm) 30" (76,2 crn) 28 5/16" (71,9 cm) 30±1116" 21 314" (55,2 cm) Min, 3G" (91,4 cm) qandard
(76,2±0,I5 cm) 22 I/8" (56,2 cm) Max 35 3/8" (90 crn) rain
G Minimum Cutout Depth is increased to 24"(61 cm) with backguar& P/N 318201667 (0406) Rev A
English - pages 1-9
NOTE: Wiring diagram for these appliances are enclosed in this booklet. Espaflo[ - p_ginas 10-18
Wiring Diagrams- pages 19-20