Publicidad
Idiomas disponibles
Idiomas disponibles
3. Adjust Temperature
In cool mode only, the temperature can be set within a range of 15°C to 31°C.
Press "
" or "
" button to increase or decrease the temperature 1°C by pressing once.
The unit LED shows the target temperature for 5 seconds and then displays the room temperature.
To Shift the temperature unit between Celsius and Fahrenheit, long press both "
when the appliance is on. The corresponding indicator of "°C" and "F" will light up.
4. Adjust Fan Speed
Press the "
" button to select a desired fan speed shown as below:
5. Power
When you press "
" button again, the unit will beep and stop working.
Notice: Each mode working principle
•
Automatic mode
1. Once the automatic operation is selected, the indoor temperature sensor detects room temperature
automatically to select the desired operation mode with
2. When the room temperature ≥24°C, the unit will automatically select
3. When the room temperature <24 °C, the unit will automatically select
•
Dehumidify mode
1. The up centrifugal fan will run at low speed, and the speed can't be adjusted.
2. The unit adopts constant temperature dehumidifying mode, and the adjustment of temperature is no
effective.
3. Connect the drain hose (not included) to the unit if use dehumidification for long time.
•
Cool mode
1. When the room temperature is higher than set temperature, the compressor starts to run.
2. When the room temperature is lower than set temperature, the compressor stops and upper fan operates
at original set speed.
•
Fan mode
1. The fan runs at set speed, and the compressor does not run.
2. The adjustment of temperature is no effective.
•
Timer on and
Timer off function
1. Press "Timer" button to set Automatically Off time while the unit is running, the timer icon light is on.
2. Press "Timer" button to set Automatically On time while the unit is in standby, the timer icon light is on.
3. The time can be adjusted within a range of 1 hour to 24 hours. Press the temp up (+) or temp down (-)
button to increase or decrease the time 1 hour by pressing once.
•
Sleep mode
1. The
operation is effective when the unit is under
2. Press the
button in
turn to low speed automatically (the speed icon light remains the previous setting). The set temperature
will increase 1°C after one hour, and increase 2°C after two hours. After six hours the unit will stop
running.
5059340368191_MNL_IN_V04.indd 59
5059340368191_MNL_IN_V04.indd 59
mode, then the unit will work under sleep mode and the up centrifugal fan will
59
or
.
mode.
mode.
.
" or "
" simultaneously
30-11-2022 14:53:37
30-11-2022 14:53:37
Publicidad
