Publicidad
Idiomas disponibles
Idiomas disponibles
Oscillation
4.
Press the oscillation button
the device beeps once and oscillates from left to right and back at an
80° angle; the light
oscillation, press the button
Power selector/anti-freeze mode
5.
Press the power selector/anti-freeze mode button
several times to switch from the lowest power to the highest power,
then to the anti-freeze mode and so on.
1) To set the heating power:
- For the lowest heating power, the light
- For the highest heating power: the light
2) For the anti-freeze mode: the light
The device automatically maintains the room temperature at 7°C. If the room temperature
is high, the heater enters standby mode.
In the anti-freeze mode, you cannot change the default temperature (7°C).
Adjusting the temperature/Eco mode
6.
1) Push the temperature control button
display (12) flashes. You then have 3 seconds to set your choice of
temperature between 15 and 35°C using the + (25) and - (24) buttons.
The temperature is saved automatically after 3 seconds and the
display stops flashing.
When the desired temperature is reached, the device stops running. It automatically
restarts when the temperature in the room drops again.
2) Push the button
(13) a second time to switch to Eco mode. The light
appears on the control panel.
The Eco mode allows the heating power to be set automatically, without your
involvement, using a temperature sensor that detects the temperature in the room in
order to save energy.
The device automatically selects:
- high heating power if the room temperature is below or equal to 18°C;
22
(16) if you want to enable oscillation:
(20) appears on the control panel. To stop the
(16) again.
(11) once or
(19) is displayed on the control panel.
(18) is displayed on the control panel.
(17) is displayed on the control panel.
(13) once. The
(22)
- low heating power if the room temperature is between 18°C and 25°C;
- off if the room temperature is above 25°C (it enters standby).
To turn off the Eco mode, press the button
settings are reactivated.
N
:
otes
- The control panel shows the set temperature and not the temperature in the room.
- If you press and hold the + (25) or - (24) button, the numbers will cycle through faster.
Screen Light On/off
7.
Press the button
(15) to turn the screen light on or off.
Programming a delayed shutdown
8.
This function is used to set the operating time after which the device will automatically
shut down.
1. With the device plugged in and operating, press the timer control
button
(22). The light
You then have 3 seconds to set your choice of duration between 1 and
24 hours using the + (25) and - (24) buttons.
2. Once the selected duration elapses, the device automatically shuts
down and enters standby mode.
N
: The control panel alternates between showing the set temperature and the timer
ote
countdown.
3. To change the timer, push the button
to set another timer.
4. To turn off a timer, push the - button (24) until the display reads "0", which
indicates that no timer is on.
Programming a delayed start
9.
This function is used to set the time after which the device will automatically turn on.
1. With the device plugged in and the main switch (9) in the "I" position (on), turn the
appliance on using the on/standby mode button
(13) again. The most recently selected
(14) appears and the display (19) flashes.
(22) and use the + (25) and - (24) buttons
(10).
23
Publicidad
