Switch On The Appliance - Fagor PBZ6VI501FTB6S6C Manual De Instrucciones

OPERATION
Control Panel
Heat setting selection sensor (2) is a slider type touch control sensor allowing selection
of heat setting (1-9 ) by touching and sliding your finger across the marked area (2):
- slide right - increase the heat setting
- slide left - reduce the heat setting
It is also possible to select the heat setting directly by touching the appropriate part of the heat
setting selection touch sensor (2).
● Immediately after the appliance is connected to electrical mains, two indicators on the right
will light up briefly. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensors, which are operated
by touching with a finger for at least 1 second.
● Touching of a sensor is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensors (this could cause an error). Touch
sensors should be always kept clean

Switch on the appliance

When the appliance is switched off then all the cooking zones are disconnected and the in-
dicators are off.
Touch the on/off sensor (1) to turn on the appliance. "0" will appear on all cooking zone dis-
plays (3) for 10 seconds. Now the desired heat setting can be set using the (+) touch sensor
(2) and the (-) touch sensor (3)
(see "setting the heating power").
If none of the sensors is touched within 10 seconds, the appliance switches
itself off.
If child lock function is activated, indicator light comes on by the Child Lock
sensor (10) and the appliance cannot be switched on (see "Releasing the child
lock").
Switch on the cooking zone
Touch the on/off sensor (1) to switch on the appliance and set the desired heat setting of
any cooking zone using the (+) (2) touch sensor or the (-) (3) touch sensor. To select the
desired heat setting, slide your finger across the setting selection sensor (2).
52
.