Troubleshooting Guide
The following check.will assist in the correction of most problems which you may encounter with
your unit.
Before going through the check list below, refer back to the connection and operating procedures.
General
Problem
Cause/Solution
The operation buttons do not
e The built-in micro computer has malfunctioned.
function.
— Press the reset button on the display unit.
* The connecting cords are not connected properly.
* The batteries in the remote commander are weak.
* The distance between the remote commander and the display
unit is too far.
The sound skips due to
* The CD changer unit is installed in an unstable location.
vibration.
— Re-install it in a stable location.
* Dirty or defective disc(s)
— Clean or replace it/them.
Error displays
EN
The following indication will flash for about five seconds and an alarm sound will be heard.
Display
Cause
Solution
ANIMm
NA H r
The disc magazine is not insertedin
Insert the disc magazine with discs into
NU
IJITO
theCDchanger.
the CD changer.
arim
nry
No disc is inserted in the disc
Take out the magazine and insert the
INU
1 1 JL
magazine.
discs.
ERROR
The disc is dirty.
Clean the disc.
The disc is inserted upside down.
Insert the disc correctly.
R E v E T
The CD changer cannot be operated
Press the reset button of the display
JC!
because of some problem.
unit.
If the above mentioned solutions do not help to improve the situation, consult your nearest Sony
dealer.
19