Publicidad
Idiomas disponibles
Idiomas disponibles
2 2 / / INSTALLING YOUR APPLIANCE
- The appliance must be unplugged during installation or when any repair or maintenance work
is being carried out.
- Ensure that the network voltage corresponds to the voltage noted on the identification plate
located inside the hood.
- If the electrical installation at your residence requires any changes in order to hook up your
Appliance, call upon a professional electrician.
Tips:
- The length of the air extraction pipe should be as short as possible.
- Limit the number of curves or angles (maximum angle of curvature 90°).
- Use an approved material with the meaning of the law.
- Avoid changes of cross-section (recommended constant diameter 150 mm).
- Pay attention to the instructions for use and installation of the extraction hood.
- If the abovementioned instructions are not complied with, the supplier will not accept liability
for any noise pollution problems and the warranty will be invalid.
• • ELECTRIC CONNECTION
This motor is delivered with a cable to be connected directly to the hood (fig 1).
Ensure that:
- the electrical installation has sufficient power,
- the electrical wires are in good condition
- the diameter of the conductors complies with the requirements of the installation.
Fig.1
Warning
If the electrical installation in your residence requires any changes in order to hook up
your appliance, call upon a professional electrician.
Warning
The hood must be installed in compliance with all applicable regulations concerning the
ventilation of premises. In France these regulations are described in DTU 61.1 from the CSTB.
In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke
from appliances that use gas or other combustible fuels. Unused ducts may only be used after
approval from a competent specialist.
31
EN
Publicidad
