Publicidad
Idiomas disponibles
Idiomas disponibles
2.3
Removing HomePlug B from HomePlug A and C network and join HomePlug D and E
(Network BDE)
The procedure is as followes:
1. Press and hold the security button on HomePlug B for about 10 seconds. Release when the power
light flashes. The password to HomePlug B has just been erased and HomePlug B removes itself
from HomePlug A and C.
2. Press and hold the security button on HomePlug D for 2 seconds. The power light starts to flash.
3. Within 120 seconds after the power light on HomePlug D starts to flash, press and hold the security
button on HomePlug B for 2 seconds and then release.
4. HomePlug B and HomePlug D are now connected to each other. Therefore, together with
HomePlug E, they will form the network BDE.
Chapter 3: Troubleshooting & disclaimer
If your HomePlug AV Ethernet Bridge has difficulty communicating with each other, check the
following:
•
Try power cycling the unit by unplugging it from the wall socket for 10 seconds and plug it in again.
•
Hold the Reset button on each HomePlug for 15 seconds and try to re-connect. The HomePlug's
light will flash, and the HomePlug will be reset and attempt to link using the default factory settings.
•
Try plugging the HomePlug into an adjacent power outlet.
•
The HomePlug works better when plugged directly into the wall power outlet. Connecting the
HomePlug to a power strip or surge protector may degrade the network performance or completely
stop network signals.
•
This HomePlug should not be used in areas with excessive heat.
•
Certain florescent or incandescent lights are noise sources for the electrical wiring and can
degrade the performance.
•
If your building has more than one circuit breaker box, your HomePlug may not be able to connect
between the different circuit breaker boxes. In this case, connect one HomePlug to a power outlet
located on each of the circuit boxes. Connect an Ethernet cable between each of the HomePlug
units to link the different HomePlug together. This will allow the HomePlug units from different
circuit breaker boxes to be connected.
•
To enter standby mode, simply remove the Ethernet cable from the HomePlug and wait about
3 minutes.
Remove HomePlug B from
Network ABC to Network DE
5
Publicidad
