Publicidad
Idiomas disponibles
Idiomas disponibles
Regulatory information
FCC Supplier's Declaration of Conformity
iRobot Corporation
Contains FCC ID: UFE-AXGY1 and contains IC: 6652A-AXGY1
This device complies with part 15 of the FCC Rules and ICES-003.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
• Changes or modifications not expressly approved by iRobot Corporation
could void the user's authority to operate the equipment.
• This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules as well as
ICES-003 Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference to radio communication will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Roomba Model: RVE-Y1
• Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than the necessary for successful communication.
• FCC Radiation Exposure Statement: This product complies with
FCC §2.1091(b) for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as
described in this manual. Per FCC requirements, maintain a distance
of more than 8 inches (20 cm) between any person and the host device
(Roomba robot).
• ISED Radiation Exposure Statement: This product complies with the
Canadian Standard RSS-102 for mobile device RF exposure limits,
set forth for an uncontrolled environment and is safe for the intended
operation as described in this manual. Per ISED requirements, maintain
a distance of more than 8 inches (20 cm) between any person and the
robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.
http://global.irobot.com
For battery recycling go to call2recycle.org; or call 1-800-822-8837
Roomba
j6+ Owner's Guide
11
®
EN
Publicidad
