Publicidad
Idiomas disponibles
Idiomas disponibles
➢ In order not to impair the function of the appliance, never cover or block
the ventilation openings/slots of the appliance cover.
➢ To ensure adequate ventilation, it is important that the clearance
between the wall and the front edge of the appliance is not less than 60
cm.
➢ To achieve the specified energy class, comply with the above mentioned
clearances.
➢ Do not install refrigerator/freezer combinations with only one
temperature regulator in refrigerated rooms below 16 °C.
For more information on installation, see the installation instructions supplied.
13 Putting into operation
Clean the appliance and the interior parts thoroughly before putting into operation (see
chapter "Service and Maintenance").
•
Set the temperature according to the ambient temperature at the installation
location if the equipment is changed or if the appliance door is opened and closed
frequently.
•
With very high summer temperatures, set the temperature regulator to a higher
level to maintain the desired cooling temperature.
•
For optimum energy consumption, leave the glass shelves/drawers in the
appliance as shown (see Fig. Fehler! Verweisquelle konnte nicht gefunden
werden.).
•
The freezer compartment is ready for use after about 3 hours.
13.1 Switching the appliance ON/OFF
1. Connect the appliance to the mains power supply.
→ When the appliance door is opened, the interior light comes on.
2. To switch on the appliance, turn the temperature regulator from "0" to the right to
the desired cooling temperature. The temperature regulator is located on the
right-hand side in the refrigerating compartment.
3. To switch off the appliance, turn the temperature regulator to position "0".
APPLIANCE DAMAGE!
Do not switch on the appliance immediately after a power interruption.
Putting into operation
Page | 35
Publicidad
