Publicidad
3
Multimeter Features
Performing manual logs (HAnd)
Ensure that
1 Press
function.
display will return to normal after a short while (around 1 second).
Figure 3-7
2 Repeat step 1 again to save the next input signal value.
The maximum number of readings that can be stored for the manual log is 100 entries.
When all entries are occupied,
is pressed for more than 1 second.
See the Reviewing Previously Recorded Data (View) section later in this manual to review
or erase the recorded entries.
Performing interval logs (AUto)
Ensure that
Set the recording interval duration
1 Press
2 Press
3 Press
seconds (default 1 second).
4 Press
step 3 to edit.
5 Press
The duration set in the steps above will determine how long each recording interval takes.
The input signal value at the end of each interval will be recorded and saved into the
multimeter's memory.
108
is selected as the data logging option in the multimeter's Setup.
for more than 1 second to store the present input signal value and
Hz
Save
and the log entry number are displayed at the top of the display. The
Manual log display
is selected as the data logging option in the multimeter's Setup.
while turning the rotary switch to access the Setup menu.
Shift
Esc
or
on
Hold
icon appears to the left of the secondary display.
Vsense
or
to change the duration or a recording interval from 1 to 99999
or
on
Hold
to save the changes. Press and hold
Hz
Save
will be shown in the secondary display when
until
is shown on the secondary display and the
to navigate to the consecutive values, then repeat
Shift
Esc
Keysight U1281A/U1282A User's Guide
Hz
until the multimeter restarts.
Save
Publicidad
