Publicidad
Preparing Your Multimeter
Check the shipment
When you receive your multimeter, check the shipment according to the following
procedure.
1 Inspect the shipping container for damage. Signs of damage may include a dented or
torn shipping container or cushioning material that indicates signs of unusual stress or
compacting. Save the packaging material in case the multimeter needs to be returned.
2 Carefully remove the contents from the shipping container, and verify that the standard
accessories and your ordered options are included in the shipment according to the
standard shipped items as below:
– Test probes
– Infrared (IR)-to-USB cable
– AA batteries (4x)
– Certificate of Calibration
3 For any question or problems, refer to the Keysight contact numbers on the back of this
manual.
Removing the holster
1 Push the top of the orange rubber holster outward and backward.
2 Push the multimeter from the back until the orange rubber holster is completely
detached from the multimeter.
Keysight U1281A/U1282A User's Guide
Introduction
1
21
Publicidad
